Asus M2N32-SLI Deluxe - Manual (Page 48)

2-22 Chapter 2: Hardware information
14. Optical S/PDIF Out port. This port connects an external audio output device
via an optical S/PDIF cable.
15. Coaxial S/PDIF Out port. This port connects an external audio output device
via a coaxial S/PDIF cable.
16. PS/2 keyboard port (purple). This port is for a PS/2 keyboard.
For Wireless Edition only:
Please refer to the wireless user guide for detail configuration and settings.
17. Wireless LAN port. This port is on the onboard wireless LAN module that
allows you to set up a wireless network and exchange information with other
wireless devices without tangling cables and wires. Connect the moveable
omni-directional antenna to this port.
18. Wireless LAN Activity LED. The wireless module comes with an activity
LED.
• DO NOT insert a different connector to this port.
• DO NOT unplug the external Serial ATA box when a RAID 0 or JBOD is
configured.
• Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cable and installed Serial ATA hard
disk drives; otherwise, you cannot enter the Silicon Image RAID utility and
SATA BIOS setup during POST.
• If you intend to create a RAID configuration using this connector, set the
Silicon 3132 Controller item in the BIOS to [RAID Mode]. See section “4.4.7
Onboard Device Configuration” for details.
• Use these ports and an external Serial ATA box connected to the external
SATA port, if you want to configure a RAID 0, 1 or JBOD set.
• The Serial ATA port multiplier and external Serial ATA box are purchased
separately.