Asus P5B-Plus VISTA Edition - Manual (Page 149)

ASUS P5B-Plus Series 5-39
5.5.3 Intel ® RAID configurations
This motherboard supports RAID 0, RAID 1, JBOD and Intel ® Matrix Storage
configurations for Serial ATA hard disks drives through the Intel ® ICH8R
Southbridge chip.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Main Menu, select IDE Configuration, then press .
3. Select the item Configure SATA As, then press to display the
configuration options.
4. Select RAID from the Configure SATA As item options, then press .
5. Select the item Onboard Serial-ATA BOOTROM, press , then select
Enabled from the options.
6. Save your changes, then exit the BIOS Setup.
Refer to the system or the motherboard user guide for details on entering and
navigating through the BIOS Setup.
5.5.2 Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance,
install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID configuration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
If you want to boot the system from a hard disk drive included in a created RAID
set, copy first the RAID driver from the support CD to a floppy disk before you
install an operating system to the selected hard disk drive. Refer to section 5.5
Creating a RAID driver disk for details.
Intel ® Matrix Storage. The Intel ® Matrix Storage technology supported by the
ICH8R chip allows you to create a RAID 0, RAID 1, RAID 5, and RAID 10 function
to improve both system performance and data safety. You can also combine two
RAID sets to get higher performance, capacity, or fault tolerance provided by the
difference RAID function. For example, RAID 0 and RAID 1 set can be created by
using only two identical hard disk drives.