Asus P4XP-X - Manual (Page 25)

ASUS P4XP-X motherboard user guide 1-15
1.12 Connectors
This section describes and illustrates the internal connectors on the motherboard.
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
2. Chassis intrusion connector (4-1 pin CHASSIS)
This lead is for a chassis designed with intrusion detection feature.
This requires an external detection mechanism such as a chassis
intrusion sensor or microswitch. When you remove any chassis
component, the sensor triggers and sends a high-level signal to this
lead to record a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. If you wish to use the chassis intrusion detection
feature, remove the jumper cap from the pins.
g the RTC RAM, never remove the cap on CLRTC1 jumper
moving the cap will cause system boot failure!
P4XP-X
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4XP-X Floppy Disk Drive Connector
PIN 1
FLOPPY1
P4XP-X
®
P4XP-X Chassis Alarm Lead
CHASSIS1
+5VSB_MB Chassis Signal GND
(Default)