Asus TS500-E5/RX8 - Manual (Page 63)

ASUS TS500-E5 4-9
4.3 Internal connectors
1. Floppy disk drive connector (34-1 pin FLOPPY1)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
®
DS
AN
-D X/ TS 50 0- E5
FLOPPY
NOTE:Orient the red markings
on the floppy ribbon cable to PIN 1.
PIN1
DSAN-DX/TS500-E5
Floppy disk drive connector
2. Serial ATA connectors [black] (7-pin SATA1-6)
These connectors, controlled by southbridge ICH9R, are for the Serial ATA
signal cables for Serial ATA hard disk drives.
®
DS AN
-D X/ TS 50 0- E5
DSAN-DX/TS500-E5
SATA connectors
SATA1 GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
SATA2 GND
RSATA_1TXP2
RSATA_TXN2
GND
RSATA_RXN2
RSATA_RXP2
GND
SATA3 GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXN3
RSATA_RXP3
GND
SATA4 GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXN4
RSATA_RXP4
GND
SATA5 GND
RSATA_TXP5
RSATA_TXN5
GND
RSATA_RXN5
RSATA_RXP5
GND
SATA6 GND
RSATA_TXP6
RSATA_TXN6
GND
RSATA_RXN6
RSATA_RXP6
GND