Asus AAM6020BI-T4 - Manual (Page 8)

AAM6030BI User Manual
3.2 Configuring Your PC
Before you start to access the CPE via Ethernet, you must configure your PC’s TCP/IP address to be 192.168.1.x,
where x is any number between 2 and 254. The subnet mask must be 255.255.255.0. Your CPE’s default IP
address is 192.168.1.1.
If you use Ethernet cable to connect your AAM6030BI and PC, you don’t need any specific driver installation.
3.2.1
Windows XP:
1. In the Windows task bar, click on the Start button, and then click on Control Panel.
2. Double-click on the Network Connections icon.
3. In the LAN or High-Speed Internet window, right-click on the icon corresponding to your network
interface card (NIC) and select Properties. (Often this icon is labeled Local Area Connection).
The Local Area Connection dialog box is displayed with a list of currently installed network
items.
4. Ensure that the check box to the left of the item labeled Internet Protocol (TCP/IP) is checked,
and click on .
.
Figure 3.7 Network
Connections in
Windows XP
Figure 3.8 Local Area Connection Properties in Windows XP
5. In the Internet Protocol (TCP/IP) Properties dialog box, click in the radio button labeled Use
the following IP address and type 192.168.1.x (where x is any number between 2 and 254) and
255.255.255.0 in the IP address field and Subnet Mask field, respectively.
3.2.2 Windows 2000:
1. In the Windows task bar, click on the Start button, point to Settings, and then select Control
Panel.
2. Double-click on the Network and Dial-up Connections icon.
3. In the Network and Dial-up Connections window, right-click on the Local Area Connection
icon, and then select Properties.
8 8