Asus P4P800 - Manual (Page 137)

ASUS P4P800 motherboard user guide 5-23
2. Select the stripe value for the RAID 0 array by scrolling through the
available values by using the Up and Down arrow keys and
pressing the key.
3. The available values range from 8 KB to 128 KB increments. The
strip value should be chosen based on the planned drive usage.
Some suggested selections are listed below. The default selection
is 64 KB.
• 16 KB - low disk usage
• 64 KB - typical disk usage
• 128 KB - performance disk usage
4. Press the key again to the Create Volume prompt to create
the array. Confirm this selection by pressing the key after the
prompt.
Are you sure you want to create this volume (Y/N)
5. Scroll to option 4 Exit and press the key to exit the RAID
configuration utility. Confirm the exit by pressing key.
5.4.5 Deleting a RAID Volume
[ HELP ]
Deleting a volume will destroy the volume data on the drive(s) and
cause any member disks to become available as non-RAID disks.
WARNING: EXISTING DATA WITHING THIS VOLUME WILL BE LOST AND NON-RECOVERABLE
Intel(R) Integrated RAID for Serial ATA - RAID Configuration Utility
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
[ DELETE ARRAY MENU ]
[ ]-Change [ ]-Change [TAB]-Next [TAB]-Next []-Previous Menu []-Previous Menu []-Delete Volume []-Delete Volume
Name Level Drives Capacity Status Bootable
RAID_Volume1 RAID0(Stripe) 2 37.2GB Normal Yes
Take caution in using this option; All data on the RAID drives will be
lost!