Asus M2V - Manual (Page 77)

ASUS M2V 4-19
MCT Timing Mode [Auto]
Appears only when the Parallel Port Mode is set to [ECP]. This item
allows you to set the Parallel Port ECP DMA.
Configuration options: [DMA0] [DMA1] [DMA3]
Bank Interleacving [Auto]
Sets whether to allow memory accesses to be spread out over BANKS
on the same node or across nodes, decreasing access contention.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ATLVID [Disabled]
Allows you to enable or disable the MemCLK Tri-Stating During C3 and
Alt VID. Configuration options: [Disabled] [Enabled]
Memory Hole Remapping [Disabled]
Allows you to enable or disable Memory Remapping around the
memory hole. Configuration options: [Disabled] [Enabled]
ECC Configuration
DRAM ECC Enable [Enabled]
4-Bit ECC Mode [Disabled]
DRAM SCRUB REDIRECT [Disabled]
DRAM BG Srub [Disabled]
l2 Cache BG Srub [Disabled]
Data Cache BG Srub [Disabled]
ECC Configuration
DRAM ECC Enable [Disabled]
Enables or disables the DRAM ECC that allows hardware to report
and correct memory errors automatically to maintain system integrity.
Configuration options: [Disabled] [Enabled]
The following item appears only when the DRAM ECC item is set to [Enabled].
4-Bit ECC Mode
Enables or disables the 4-Bit ECC mode.
Configuration options: [Disabled] [Enabled]
DRAM SCRUB REDIRECT [Disabled]