Asus M2V - Manual (Page 23)

ASUS M2V 2-1
2.1 Before you proceed
Note of the following precautions before you install motherboard
components or change any motherboard settings.
Onboard LED
The motherboard comes with a standby power LED. When lit, this green
LED indicates that the system is ON, in sleep mode, or in soft-off mode,
a reminder that you should shut down the system and unplug the power
cable before removing or plugging in any motherboard component. The
illustration below shows the location of the onboard LED.
• Unplug the power cord from the wall socket before touching any
component.
• Use a grounded wrist strap or touch a safely grounded object or
to a metal object, such as the power supply case, before handling
components to avoid damaging them due to static electricity.
• Hold components by the edges to avoid touching the ICs on them.
• Whenever you uninstall any component, place it on a grounded
antistatic pad or in the bag that came with the component.
• Before you install or remove any component, ensure that the ATX
power supply is switched off or the power cord is detached from
the power supply. Failure to do so may cause severe damage to
the motherboard, peripherals, and/or components.
M2V
M2V Onboard LED
SB_PWR
ON
Standby
Power
OFF
Powered
Off