Asus P8H61-M PRO - Manual (Page 63)

Chapter 2: BIOS information 2-19
CPU C1E [Enabled]
[Enabled] Enables the C1E support function. This item should be enabled in order to
enable the Enhanced Halt State.
[Disabled] Disables this function.
CPU C3 Report [Disabled]
Allows you to disable or enable the CPU C3 report to OS.
Configuration options: [Disabled] [Enabled]
CPU C6 Report [Enabled]
Allows you to disable or enable the CPU C6 report to OS.
Configuration options: [Enabled] [Disabled]
2.5.2 System Agent Configuration
The System Agent Configuration menu allows you to change the northbridge chipset settings.
Initiate Graphic Adapter [PEG/iGPU]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [iGPU] [PEG/iGPU]
iGPU Memory [64M]
Allows you to set the Internal Graphics Device share memory size.
Configuration options: [32M] [64M] [96M] [128M]
Render Standby [Enabled]
Allows you to enable or disable Render Standby by Internal Graphics Device.
Configuration options: [Disabled] [Enabled]
iGPU Multi-Monitor [Disabled]
Allows you enable or disable Internal Graphics Device Multi-Monitor Support for add-on VGA
devices. Configuration options: [Disabled] [Enabled]
2.5.3 PCH Configuration
High Precision Timer [Enabled]
Allows you to enable or disable the High Precision Event Timer.
Configuration options: [Disabled] [Enabled]
2.5.4 SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.
SATA Mode [IDE Mode]
Allows you to set the SATA configuration.
[Disabled]
Disables the SATA function.
[IDE Mode] Set to [IDE Mode] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.