Asus TX97-X - Manual (Page 13)

ASUS TX97-X User’s Manual 13
III. INSTALLATION
Jumpers
1) RTCLR p. 15 Real Time Clock RAM (Operation/Clear Data)
2) AUDIO (optional) p. 15 Onboard Audio (Disable/Enable)
3) M/IO p. 16 Multi-I/O Selection (Enable/Disable)
4) FS0, FS1, FS2 p. 16 CPU External Clock (BUS) Frequency Selection
5) BF0, BF1, BF2 p. 16 CPU:BUS Frequency Ratio
6) VID0, 1, 2, 3 p. 18 CPU Voltage Regulator Output Selection
Expansion Slots
1) System Memory p. 19 System Memory Upgrade
2) CPU ZIF Socket 7 p. 22 Central Processing Unit (CPU) Socket
3) SLOT 1, 2, 3, 4 p. 23 16-bit ISA Bus Expansion Slots *
4) PCI 1, 2, 3, 4 p. 23 32-bit PCI Bus Expansion Slots †
Connectors
1) PS2KEYBOARD p. 25 PS/2 Keyboard Connector (6-pin Female)
2) PS2MOUSE p. 25 PS/2 Mouse Connector (6-pin Female)
3) PRINTER p. 26 Parallel (Printer) Port Connector (25-pin Female)
4) COM1, COM2 p. 26 Serial Port COM1 & COM2 (Two 9-pin Female)
5) FLOPPY p. 26 Floppy Drive Connector (34-pin Block)
6) AUDIO (optional) p. 27 Audio Port -Line Out, Line In, Mic (Three 1/8” Female)
7) GAME (optional) p. 27 Joystick/Midi Connector (15-pin Female)
8) USB p. 27 Universal Serial BUS Ports 1 & 2 (Two 4-pin Female)
9) Primary / Second IDE p. 28 Primary / Secondary IDE Connector (40-pin Blocks)
10) IDELED
p. 28 IDE LED Activity Light
11) FANPWR1, 2, 3 p. 29 1 Chassis, 2 CPU, 3 Power Supply Fan Power Lead (3-pin Block)
12) CHASSIS p. 29 Chassis Open Alarm Lead (4-1pin Block)
13) IR p. 30 Infrared Port Module Connector
14) ATXPWR p. 30 ATX Motherboard Power Connector (20-pin Block)
15) VOLCTL (optional) p. 31 Digital Volume Level Control (Up/Down)
16) WOL p. 31 Wake on LAN (3 pins) (RESERVED)
17) MSG LED (PANEL) p. 32 System Message LED (2 pins)
18) SMI (PANEL)
p. 32 SMI Switch Lead (2 pins)
19) PWR SW (PANEL) p. 32 ATX Power & Soft-Off Switch Lead (2 pins)
20) RESET (PANEL) p. 32 Reset Switch Lead (2 pins)
21) PWR LED (PANEL) p. 32 System Power LED Lead (3 pins)
22) KEYLOCK (PANEL) p. 32 Keyboard Lock Switch Lead (2 pins)
23) SPEAKER (PANEL) p. 32 Speaker Output Connector (4 pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards must not
use this address or else conflicts will occur.
(Map of Board)
III. INST
ALLA
TION