Asus P4S333-VF - Manual (Page 44)

2-22 Chapter 2: Hardware information
5. ATX power connectors (20-pin ATXPWR, 4-pin ATX+12V)
These connectors connect to an ATX 12V power supply. The plugs from
the power supply are designed to fit these connectors in only one
orientation. Find the proper orientation and push down firmly until the
connectors completely fit.
In addition to the 20-pin ATXPWR connector, this motherboard requires
that you connect the 4-pin ATX +12V power plug to provide sufficient
power to the CPU.
Make sure that your ATX 12V power supply can provide 8A on the
+12V lead and at least 1A on the +5-volt standby lead (+5VSB). The
minimum recommended wattage is 230W, or 300W for a fully
configured system. The system may become unstable and may
experience difficulty powering up if the power supply is inadequate.
P4S333-VF
®
P4S333-VF ATX Power Connectors
ATX12V
+12V DC COM
+12V DC COM
Pin 1
ATXPWR
Pin 1
+3.3VDC -12.0VDC COM PS_ON# COM COM COM -5.0VDC +5.0VDC +5.0VDC
PWR_OK
+12.0VDC
+3.3VDC +3.3VDC
COM
+5.0VDC
COM
+5.0VDC
COM
+5VSB
6. USB header (10-1 pin USB1)
If the USB port connectors on the rear panel are inadequate, a USB
header is available for additional USB port connectors. Connect the
bundled 2-port USB connector set to this header and mount the USB
bracket to an open slot in the chassis.
P4S333-VF
®
USB P4- USB P4+
USB Power
GND
1
USB P3- USB P3+ USB Power GND NC
2
9
10
P4S333-VF USB Header
USB2