4 storage configuration, 5 primary ide master/slave, Onboard ide controller [enabled – Asus M2N68 User Manual
Page 60: Serial-ata devices [enabled, Sata mode select [sata mode

2-16
Chapter 2: BIOS setup
2.3.4
Storage Configuration
The items in this menu allow you to set or change the configurations for the IDE or
Serial-ATA devices installed in the system. Select an item then press
wish to configure the item.
Storage Configuration
Onboard IDE Controller
[Enabled]
Serial-ATA Devices
[Enabled]
SATA Mode select
[SATA Mode]
Onboard IDE Controller [Enabled]
Allows you to enable or disable the onboard IDE controller.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Enabled]
Allows you to enable or disable the serial-ATA devices.
Configuration options: [Disabled] [Enabled]
SATA Mode select [SATA Mode]
Configuration options: [SATA Mode] [RAID Mode] [AHCI Mode]
2.3.5
Primary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press
Primary IDE Master
Device : Hard Disk
Vendor : ST320413A
Size : 20.0GB
LBA Mode : Supported
Block Mode : 16 Sectors
PIO Mode : Supported
Async DMA : MultiWord DMA-2
Ultra DMA : Ultra DMA-5
SMART Monitoring: Supported
Type
[Auto]
LBA/Large Mode
[Auto]
Block(Multi-Sector Transfer) M
[Auto]
PIO Mode
[Auto]
DMA Mode
[Auto]
SMART Monitoring
[Auto]
32Bit Data Transfer
[Enabled]
Exit
Disabled: disables
the integrated IDE
Controller.
Enabled: enable
the integrated IDE
Controller.
Select the type
of device connected
to the system.