Asus A7N8X-VM/400 - Manual (Page 39)

ASUS A7N8X-VM 400 Motherboard 2-9
MDA Access Control [PCI]
This field selects the MDA Access cycles direction. Configuration options: [AGP]
[PCI]
Primary Video [PCI]
This will switch the PCI Bus scanning order while searching for a video card. This
allows the user to select the type of Primary VGA in case of multiple video
controllers. Configuration options: [PCI] [AGP/Onboard]
Onboard TV-out format [PAL]
This field sets the onboard TV-out format. Configuration options: [PAL] [NTSC]
2.4.2 Onboard Devices Configuration
Onboard Floppy Controller [Enabled]
This field allows you to enable or disable the onboard floppy controller.
Configuration options: [Enabled] [Disabled]
Serial Port1 Address [3F8/IRQ4]
This field allows you to disable or set the address for the onboard serial port 1
connector. Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4]
[2E8/IRQ3]
Serial Port1 Mode [Normal]
This field allows you to set the serial port 1 mode. Configuration options: [Normal]
[IrDA] [ASK IR]
Parallel Port Address [378]
This field allows the BIOS to select the Parallel Port Base Address. Configuration
options: [Disabled] [378] [278] [3BC]
Configure ITE8712 Super IO Chipset
Onboard Floppy Controller [Enabled]
Serial Port1 Address [3F8/IRQ4]
Serial Port1 Mode [Normal]
Parallel Port Address [378]
Parallel Port Mode [ECP]
ECP Mode DMA Channel [DMA3]
Parallel Port IRQ [IRQ7]
SMBus Interface [Enabled]
Modem CODEC Interface [Auto]
Audio CODEC Interface [Auto]
Onboard LAN Interface [Enabled]
Onboard LAN Boot ROM [Disabled]