26 chapter 5: software support, Select the replacement drive then press Page 136
Page 136
5-26
Chapter 5: Software support
FastBuild (tm) Utility 2.00 (c) 2002-2005 Promise Technology, Inc.
[ Select Drive for Rebuild ]
[ View Array Definition Menu ]
Array No RAID Mode Total Drv
Status
Array 1
Mirror/Stripe
4
Critical
Stripe Block:
Not Available
Gigabyte Boundary:
ON
Channel: ID
Drive Model
Capacity (MB)
3:Mas FUJITSU MPD3043AT
4325
[ Keys Available ]
[ ] Up [ ] Down [ESC] Exit [Enter] Select
[ ] Up [ ] Down [ESC] Exit [Enter] Select
7. Select the replacement drive then press
FastBuild (tm) Utility 2.00 (c) 2002-2005 Promise Technology, Inc.
[ Keys Available ]
[ ] Up [ ] Down [ESC] Exit [Enter] Select
[ ] Up [ ] Down [ESC] Exit [Enter] Select
[ Rebuild Array Menu ]
Array No RAID Mode Total Drv Capacity Status
Array 1 Mirror/Stripe 4 7999 Critical
Array 2 ----- ----- ----- -----
Array 3 ----- ----- ----- -----
Array 4 ----- ----- ----- -----
8. Confirm the command to copy data from the intact source hard disk
into a new replacement hard disk. A progress bar displays the copy
progress for the duration of the task.
9. When completed, the utility prompts you to reboot the system. Press
any key to reboot your system.
Controller Configuration (6): This command shows the default for
Controller Configuration. The default value is [Enabled].