Net Optics 10 GigaBit In-Line Regeneration Taps User Manual
Page 9
5
10 GigaBit In-Line Regeneration Tap
Installing the 10 GigaBit Regeneration Tap
The Regeneration has two network connectors are labeled A and B . Depending
on your Tap model, there are either four or eight connectors for monitor devices .
Warning: The intended use of this product is in systems that contain lasers . Use
caution when handling unconnected fiber.
DANGER: Invisible Laser Radiation when open or when operating with fiber
disconnected . AVOID DIRECT EXPOSURE TO THE BEAM . Never operate
unit with a broken fiber or with a fiber connector disconnected.
CAUTION: There are no user serviceable parts inside . Refer all servicing to
qualified Net Optics service personnel.
To mount and power the Regeneration Tap:
1 . If you are rack mounting the Regeneration Tap, insert the Tap in an available
one rack unit space and secure with the four fasteners included with the Tap .
2 . Check that connector dust covers are in place .
3 . Connect the redundant power connectors to separate power sources .
4 . Secure the AC power cables with the connector clips .
5 . Check the power LEDs to verify that the Tap is receiving power .