Connecting to the monitoring device, Figure 6: connecting to the monitoring device – Net Optics 10_100BaseT Multi-Station Tap User Manual
Page 11
10/100 Multi-Station Tap
7
Connecting to the Monitoring Device
1 . Supply power to the Tap using the two redundant power supplies included
with the unit . Verify that the Power LED illuminates .
2 . Connect Monitor Port A to the appropriate port on the monitoring device
using a CAT5 straight-through cable .
3 . Connect Monitor Port B to the appropriate port on the monitoring device
using a CAT5 straight-through cable .
Note: _______________________________________________________________
The second power supply is available to support the flow of traffic to the
monitoring device in the event that the first power supply becomes
unavailable.
______________________________________________________________________
Figure 6: Connecting to the Monitoring Device
4 . Repeat Steps 2-3 for each monitoring device you wish to connect to the
10/100 Multi-Station Tap .
To monitoring device
To monitoring device
19
20
17
18
15
16
13
14
11
12
9
10
7
8
5
6
3
4
1
2
®
A
B
A
B
A
B
A
B
A
B
High Density Tap 10/100 Ethernet
Monitor
1
2