Net Optics Fiber Mode Converters - Manual (Page 8)

Fiber Mode Converter
4
Connecting to the Network
1. Unpack the Fiber Mode Converter, verify that you have all components,
and obtain the required cables needed to successfully install the unit. Your
package should contain: one Converter, one power supply, one power cord
and one users Manual (this manual).
2. Multimode Ports: Using a duplex SC multimode cable, connect the appro-
priate switch, server, or router to the Fiber Mode Converter's Multimode
Port .
3. Singlemode Ports: Using a duplex SC singlemode cable, connect the appro-
priate switch, server, or router to the Fiber Mode Converter's Singlemode
Port .
4. Supply power to the Fiber Mode Converter using the power supply included
with the unit .
5. Compare the LEDs on the Fiber Mode Converter to the chart below to
verify correct setup.
• PWR: Power .
Power LED (in side of unit) illuminates green when device is powered on.
• MM: Multimode Fiber Link.
This LED illuminates green when a good fiber optic link is established.
• SM: Singlemode Fiber Link.
This LED illuminates green when a good fiber optic link is established.
• LF: Link Fault.
This LED illuminates yellow when a link fault is present.