AEG DI7490-M User Manual

Page 23

INSTALLATION

FLUE ASSEMBLY - MOUNTING THE HOOD BODY

• Position the upper chimney section and fix the

upper part to the frame using the 2 screws

12c

(2,9 x 6,5) provided.

• Similarly, position the lower chimney section and

fix the lower part to the frame using the 2 screws

12c (2,9 x 6,5) provided.

Before fixing the hood body to the frame:

• Screw the 2 screws

12f half way into the holes

provided in the sides of the bottom of the frame.

• Remove the grease filters from the hood canopy.

• Remove any activated charcoal filters.

• Lift the hood canopy and engage the screws

12f

in the slots (

A) as far as they will go.

• Working from below, fix the hood canopy to the

frame (

B), using the 4 screws 12q and 4 washers

22 provided, then tighten all the screws securely.

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-

pole switch ha-ving a contact gap of at least 3

mm.

• Remove the grease filters (see paragraph Mainte-

nance) being sure that the connector of the feed-

ing cable is correctly inserted in the socket placed

on the side of the fan.

• Connect the control connector

Cmd.

• Connect the lights connector

Lux.

• Place the connectors in the junction box

24 and

close it using the 2 screws

12e (2,9 x 9,5) pro-

vided.

• Fix the junction box to the hood body using the 2

screws

12c (2,9 x 6,5) provided.

• For the recirculation version, fit the activated car-

bon odour fil-ter.

• Replace the grease filters.

�

��

��

��

��