AEG DI7490-M - Manual (Page 22)

INSTALLATION 22
CONNECTION IN DUCTING VERSION
When installing the ducting version, connect the
hood to the chimney using either a flexible or rigid
pipe ø 150 or 120 mm, the choice of which is left
to the installer.
To install a ø 150
• To install the dumper 10.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
To install a ø 120
• To install a ø 120 mm air exhaust connection, insert
the reducer flange 9 on the dumper 10.
• Fix the pipe in position using sufficient pipe clamps
(not supplied).
• Remove any activated charcoal filters.
CONNECTION IN RECYCLING VERSION
• Insert the Connector extensions 14.1 into the side of
the Connector 15.
• Insert the Connector 15 into the Support bracket 7.3
and fix it with the screws.
• Fasten the Support bracket 7.3, fixing it to the upper
part with the Screws.
• Make sure that the Connector extensions outlet
14.1 is in correspondence with the Chimney open-
ings both horizontally and vertically.
• Join the Connector 15 to the Hood canopy outlet
using a rigid or flexible pipe ø¸150 mm, selection of
which is at the discretion of the installation techni-
cian.
• Make sure that the Activated charcoal odour filter
has been fitted.
�����
��
��
�
��
�����
��
���
���
���
���
��
����