Theatre Solution Prima Auditorium Seating - Manual (Page 33)

32 Specifications Prima Auditorium Seating
Prima Specifications – Theatre Seating
(This section pertains to the Prima C1-U/W chair models.)
PART 3 – OPTIONS
3.1 AISLE LIGHT
A. Aisle lights shall be provided in accordance to the locations shown on the architectural drawings. The units
shall be of low voltage (24v) type and the light shall be attached to the upholstered leg panel. The leg
panel shall be prepared to accept the power wire. The necessary access holes and blank cover plates
shall be provided. The chair manufacturer shall also provide the necessary transformers. All wiring and
electrical connections shall be conducted at the job site and shall be the responsibility of others.
3.2 HARDWOOD EDGES, OUTER BACK
A. Outer plywood back panel shall be trimmed in 1/8” thick hardwood on the top and vertical edges. The
hardwood shall match the face veneer species and be stained to match.
3.3 INSET UPHOLSTERY, BACK
A. Back upholstery shall be inset to expose the veneer face on the inside of the outer back panel. The veneer
on the inside face on the back panel shall match the veneer species on the outside face and be stained to
match.
3.4 SEAT AND ROW IDENTIFICATION TAGS
A. Provide manufacturer’s standard shape brass number and letter plates. Font shall be Times Roman. The
size of the font on the seat number plates shall be 27pt; the size of the font on the row letter plates shall be
42pt. The number plates shall fit into a recessed area at the top edge of the seat. The row letter plates
shall be attached to the back of the integrated armrest with spiral shank nails.
3.5 BOOKRACKS
A. The bookrack shall be constructed of hardwoods and hardwood plywood. Bookrack shall be assembled
with tongue and groove construction and finished with a catalyzed lacquer. The bookrack shall be attached
to the outer surface of the chair back. An optional attachment configuration shall consist of a steel
weldment attached to the chair leg. This configuration allows the bookrack to be located between chair
backs.
3.6 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133