SCANTECH ID (Champtek company) IG300BT - Manual (Page 17)

17
6. Operating Settings
6.1 Factory Default
Set Scanner /Cradle factory default
The scanner and cradle factory default settings are
shown with bold
< > in the following pages.
Reset all configuration parameters to their factory
default setting. After this reset you must select all
required parameters that meet applications.
6.2 Scanning Triggering
A reading session begins (lighting and decode
processing on) when beam is activated and stops
when beam is deactivated.
Continuous Scanning
When the scanner is turned on a continuous reading
session begins (lighting and decode processing on).
Pulse
A reading session begins when beam is activated
and stays on until a period of inactivity lasting the
time specified by the timeout.
After the timeout, the scan engine turns off.