SCANTECH ID (Champtek company) IG300BT - Manual (Page 11)

11
4. Set up Bluetooth
Communication
Before the operation, Bluetooth Communication must
be set up between the scanner and cradle.
4.1 Pairing
Each scanner has to be linked or paired to a cradle
by scanning the unique Bluetooth MAC address code
located on the bottom of cradle. The pairing between
scanner and cradle is one to one that is one scanner
can be paired to a cradle only.
4.2 Set up Master Mode
Communication
Please follow the steps to set up the communication
between the scanner and cradle.
1) The scanner must scan “Scanner Master Mode”
barcode, to set the scanner in Master mode.
2) Scan the Bluetooth MAC address code located on
the bottom of the cradle.
3) When the Bluetooth MAC address code was
successfully scanned, scanner will sound 2 short
beeps with blue and red LED flash once.
4) Wait approximately five seconds, for completing
the connection process with a long beep sound.
5) If successful, Blue LED of scanner will slow flash
and the cradle will be continued on.
6) If the connections failed the scanner indicates
with 3 shot beeps and the cradle with blinking
blue LED.