Xoro HRT 7000 - Manual (Page 13)

HRT 7000 13
Engl
ish
Connection
You have the possibility to transmit the digital audio signal to a decoder or amplifier. Therefore use
the coaxial output.
1. Switch off and unplug all devices
2. Connect the receiver and the TV with a SCART or HDMI cable
3. Connect the HRT 7000 to the decoder or amplifier (coaxial cable)
4. Switch on all devices
5. Activate the coaxial input at your decoder or amplifier
Notes:
•
The Cables are not part of the accessories
•
There a just a few channels which use digital audio.
•
You can gain information about the audio signal by pressing the AUDIO key on your
remote control
Insert one end of the audio (Cinch [RCA]) cable into the white/red Cinch [RCA] socket L/R AUDIO
OUT at the back of the device and the other end into the audio input socket (usually white/red) on
the amplifier set or TV set (usually labelled “AUX IN” / “Stereo IN”). Please also refer to your
Amplifier or TV sets user manual.
Switch on the Amplifier and select the AUX or Stereo input.
To external decoder or amplifier
Stereo Analogue Output