Billet Specialties Power Steering Hose Kit for Remote Reservoir - Manual (Page 3)

500 Shawmut Avenue • La Grange, Illinois 60526 • Tech Line 708/588-0505 • Fax 708/588-7181
Clean the hose and blow out with compressed air to clear any debris.
Repeat until finished.
Step 4: Assemble Hose Ends to Hose
Install the threaded socket end on the hose and
slide it back out of the way.
Insert the nipple portion of the hose end into
the Teflon part of the hose to size it up then
remove it.
Next push the brass ferrule around the Teflon
and in between the braided hose. Seat the
Teflon hose squarely against the bottom of the
ferrule; this can be done by pushing the hose
and sleeve against a workbench or vise.
Example
Follow by placing the hose end in a vise,
sparingly lubricate the threads with 30wt oil or
similar. Insert the hose over the nipple making
sure the ferrule does not pop of the Teflon tube.
Finish by threading the socket end onto the
nipple by hand.
Now tighten with a wrench until the gap
between the nipple and the socket is no more
than 1/16”.
Step 5: Install Hoses
Install hose assembly to each component. Check and make sure the lines are
free and clear of any moving parts.