Billet Specialties Premium Tru Trac Serpentine System - Pontiac User Manual

Page 9

www.billetspecialties.com

Figure 12: Install Crankshaft Pulley

Apply anti-seize to the four 5/16-18 x 1” socket head cap screws.

[A] Place the crank pulley on the damper, thread the four 5/16-18 x 1” socket head cap
screws with bellville washers (cup facing pulley) through pulley and into damper, tighten
firmly (46ft/lbs).

Figure 13: Install Water Pump Pulley

Apply anti-seize to the four 5/16-24 X 3/4” socket head cap screws.

[A] Place water pump pulley on water pump shaft, thread the four 5/16-24 X 3/4” socket
head cap screws through the nose cone, pulley and into the water pump flange, tighten
firmly (28 ft/lbs).

Figure 14: Install Idler Pulleys

Apply anti-seize to the following:
(2) 3/8-16 x 1-3/4” 12pt. cap screws
(1) 3/8-16 x 2” 12pt. cap screw

[A] Install the first pulley by threading the 3/8-16 x 1-3/4” 12pt. cap screw through the
pulley cover, pulley and boss into the bridge bracket as shown; tighten firmly (46 ft/lbs).

[B] Install the next pulley by threading the 3/8-16 x 1-3/4” 12pt. cap screw through the
pulley cover, pulley and boss into the bridge bracket as shown; tighten firmly (46 ft/lbs).

[C] Finish by installing the lower right driver side pulley using the 3/8-16 x 2” 12pt. cap
screw in location as shown.

Figure 11: Install Power Steering Pump & Pulley

For kits without power steering continue to Figure 11.

Apply anti-seize to the two 5/16-18 x 2-3/4" socket head cap screws.

[A] Place power steering pump to bracket and thread the two 5/16-18 x 2-3/4” socket head
cap screws with 5/16" split washers through the power steering pump bosses and into the
power steering bracket and tighten firmly (26 ft/lbs).