Billet Specialties Premium Tru Trac Serpentine System - 348__409 Chevy - Manual (Page 8)

www.billetspecialties.com • Tech Line 708.588.0505 14 348/409 Chevrolet Tru Trac - 14400 / 14420 15
Figure 9: Install Power Steering Pump
For kits without power steering continue to Figure 10.
Apply anti-seize to the following:
(2) 5/16-18 x 2-3/4" socket head cap screws
[A] Place power steering pump to bracket and thread the two 5/16-18 x 2-3/4” socket head
screws with 5/16" split washers through the power steering pump bosses and into the power
steering bracket and tighten firmly (26 ft/lbs).
Figure 10: Install Crankshaft Pulley
Apply Loctite to the following:
(3) 3/8-24 x 3/4” socket head cap screws
[A] Place the crank pulley on the damper, thread the three 3/8-24 x 3/4” socket head screws
with bellville washers (cup facing pulley) through pulley and into damper, tighten firmly
(46ft/lbs).
Figure 11: Install Water Pump Pulley
Apply Loctite to the following:
(4) 5/16-24 x 3/4” socket head cap screws
[A] Place water pump pulley on water pump shaft, thread the four 5/16-24 x 3/4” socket
head cap screws through the pulley and into the water pump flange, tighten firmly
(28 ft/lbs).
IMPORTANT
DO NOT START MOTOR until you have completely installed ALL power steering hoses,
reservoir, and added power steering fluid to the system. A bleeding procedure sheet is
included with this kit.
• Power steering fluid is the lubricant for the pump.
• Serious Damage will occur to power steering pumps if they are run dry.
• Pumps that have been run dry are not warrantable.
NOTE: Automatic Transmission Fluid (ATF) should never be used in place of a quality brand
name power steering fluid.
[A] [A]
[A]
Cup of washer towards engine >