SENA Parani-ESD1000 - Manual (Page 49)

49
B.3.31. AT+PASS=$string

Response Remote Configuration Enabled 
Purpose Input password in remote configuration mode.
Parameters $string= Password (Default=”0000”)
Description Input password for authentication in remote configuration mode.
Example AT+PASS=1234
B.3.32. AT+CHPASS=$string

Response  OK
Purpose Change password used in remote configuration mode.
Parameters $string= New password
Description Change password used in remote configuration mode. Password length is up to 8.
Example AT+CHPASS=12345678
B.3.33. ATSnn?

Response  value
 OK
Purpose Display a given S-register
Parameters nn= Address of S-register
Description A specific S-register will be displayed.
B.3.34. ATSnn=mm

Response  OK
Purpose Change S-register value
Parameters nn= Address of S-register
mm= New value of S-register
Description Some S-registers are optimized for the overall performance and protected and cannot be
changed. When users try to change these S-registers, response is ‘ERROR’.
For details of S-register, refer Appendix. B.
Example ATS10=0