SENA Parani-ESD100V2-110V2 - Manual (Page 49)

49
B.3.31. AT+BTLPM,n
Response  OK
Purpose Set low power mode
Parameters n=0: Inactivate (Default)
n=1: Activate
Description During no data transmission, Parani-ESD can be in low power mode to save the power. It
takes a few seconds to wake the Parani-ESD out of low power mode.
B.3.32. AT&V
Response  S0:m0;S1:m1; …Sn:mn
 OK
Purpose Display all the S-registers
Description All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
B.3.33. AT+PASS=$string
Response Remote Configuration Enabled
Purpose Input password in remote configuration mode.
Parameters $string= Password (Default=”0000”)
Description Input password for authentication in remote configuration mode.
Example AT+PASS=1234
B.3.34. AT+CHPASS=$string
Response  OK
Purpose Change password used in remote configuration mode.
Parameters $string= New password
Description Change password used in remote configuration mode. Password length is up to 8.
Example AT+CHPASS=12345678
B.3.35. ATSnn? 
Response  value
 OK
Purpose Display a given S-register
Parameters nn= Address of S-register
Description A specific S-register will be displayed.