SENA Parani-ESD100V2-110V2 - Manual (Page 32)

32
5. Approval Information
5.1. FCC
FCC Rule: Part 15 Subpart C Section 15.247
FCCID: S7APARANIESD1XXV2
5.1.1. FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
Including interference that may cause undesired operation
Information to User
This equipment has been tested and found to comply with limits for a Class B digital device, Pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generate, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by on or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver-Connect the equipment into an
outlet a circuit different form that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
5.1.2. RF Exposure Statement
The equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operation in conjunction with any
other antenna or transmitter.
5.1.3. Do not
Any changes or modifications to the equipment not expressly approved by the party responsible for
compliance could void user‟s authority to operate the equipment.
5.2. CE
Declare under our own responsibility that the product
Bluetooth Module
Brand name: SENA
Model No.: Parani-ESD1XXV2
Parani-ESD100V2 / Parani-ESD110V2
To which this declaration refers conforms with the relevant standards or other standardizing
documents
EN 60950-1
ETSI EN 301 489-1
ETSI EN 301 489-17
ETSI EN 300 328
According to the regulations in Directive 1999/5/EC