SENA HD1200 User Manual
Page 53
Starter Kit and User Manual for the HelloDevice 1200
50
3) Configure the network environment set-up of your PC so that it can communicate with the HelloDevice.
TCP/IP parameters of network configuration should be modified temporarily.
e.g. Let’s say that IP address of the HelloDevice is 192.168.1.23 and that of your PC is 172.168.1.22. Modify the
IP address of your PC and gateway as shown in the following picture.
You may modify the IP address to different IP address of 192.168.1.xx other than 192.168.1.23, since those
addresses can also be working in the subnet. Then, press [OK] button. You will have to keep in mind your
original network environment set-up parameters, since this is temporary set-up for IP address reconfiguration of
the HelloDevice.
4) Make sure if your PC can communicate with the HelloDevice by using ping utility
>> ping 192.168.1.23
>> Pinging 192.168.1.23 with 32 bytes of data:
Reply from 192.168.1.23: bytes=32 time=10ms TTL=251
Reply from 192.168.1.23: bytes=32 time<10ms TTL=251
Reply from 192.168.1.23: bytes=32 time=10ms TTL=251
5) Run the HelloDevice Utility program
6) Take steps described in chapter 4.3.2, “Changing IP address”