SOLO 444 Motorsprühgerät - Manual (Page 26)

Assembly ; Adjustment of shoulder straps
ENGLISH 10
6. Assembly
Completely assembly the mistblower before its first use:
Assembly of misting equipment
Attach the blower elbow (1) to the blower housing and secure with both screws (Fig.4D; A+B). Ensure the
elbow can swivel easily. Push pleated hose onto blower elbow and secure with clamp (4).
Assembly of handle, spray tube and spray nozzle
Push handle (5) onto spray tube (start from the front) and fix in the required position (Fig.4C). A guide (7)
on the spray tube will ensure vertical positioning.
Push the spray tube with twist coupling (11) into the pleated hose (5) until locked. Secure with clamp (8).
Note: The spray tube can be twisted and turned in the pleated hose with the handle. Ensure that all hose
and cable connections are safe and without sharp bends.
Place spray nozzle (9) on to spray tube (vertical to handle) and secure (10).
Push formula delivery hose (2 pieces) on nipple of the handle and to the spray nozzle. Secure the hose
alongside the pleated hose. Shut on/off tap (vertical position), fill some plain water in formula tank and
check for any leakage.
7. Adjustment of shoulder straps
Place the mistblower on the back and connect to
quick couplings on either side.
The straps can be adjusted to the required length
with friction slides. Simply pull down both strap ends
to tighten straps (a).
Strap tension can be released by lifting both friction
slides (b).
Note:
The shoulder straps are correctly adjusted when the
back plate of the mist-blower rests firmly against the
back of the operator.
Fig. 4
Fig. 5