Ocean Optics INLINE-TTL-S User Manual
Page 8
1: Setup
2
000-10000-090-02-201401
Unpacking
►
Procedure
1. Unpack your lamp assembly carefully. Although the deuterium lamp is rigidly mounted, dropping
this instrument can cause permanent damage.
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present. Contact your dealer for repair or replacement information, if
necessary.
3. Use this instrument in a clean laboratory environment (see
Contents
Your package should contain the following:
Inline-TTL-S Inline TTL Shutter
One IC-DB15-2 interface cable for shutter operation
Additionally, you will need an approved power supply for the LS-475, such as the Mikropack PS-
12V/1.25A power supply.
►
Procedure
To set up your Inline TTL Shutter review the figures on the previous page and perform the following
procedure:
1. Plug in the power supply.
2. Plug the power supply connector into the INLINE-TTL-S sleeve.
3. Remove the SMA connector caps.
4. Connect the SMA connectors on your fibers to the SMA plugs on each end of the INLINE-TTL-S
shutter.
5. Plug the SUB-D 15-pol. connector into the sleeve for automatic TTL operation (cable included).
You have now configured the INLINE-TTL-S for use.