Ocean Optics USB Programmer - Manual (Page 5)

USB Programmer Installation and Operation Instructions
000-20000-080-01-201009 5
Note
Do not interrupt the programming process for any reason! If the programming
process is interrupted, permanent corruption can occur in the EEPROM on the
USB device. Consult the Recovering a Corrupted EEPROM section of this
document for a procedure that may rectify this condition.
10. Disconnect the USB device from the PC once programming is complete.
11. Reattach the USB device to the PC to activate the new program.
12. Wait 10 seconds and click the Refresh Tree button.
The device should appear in the appropriate category.