Ocean Optics USB-TC - Manual (Page 2)

USB-TC Instructions
2 172-00000-100-01-201210
Set-up
Supplying Power
The USB-TC must receive 12 VDC power to operate. It can be powered from either a 12 VDC power
supply (included), or by wiring the device directly to a 12 VDC (3.0 Amps) power source.
Caution
When power is applied, ensure that the unit is not exposed to temperatures over
60 °C, or the over-temperature protection will activate, requiring a return of the
unit to the factory to be reset.
It is recommended that the unit be left on unless you plan to have it powered off
for longer than 24 hours.
►
Procedure
To attach the 12 VDC power supply,
1. Insert the power supply cable into the 12 V connector on the front panel of the USB-TC.
2. Plug the power supply into the appropriate electrical outlets.
►
Procedure
To wire the USB-TC directly to a 12 VDC power supply,
1. Connect the +12 VDC wire to Pin 1 and the common wire to Pin 2 in the push terminal
connector inside the USB-TC.