Ocean Optics Multimode Spectrum − Lab Versions - Manual (Page 19)

2: Set-up and Operation
Shutting Down the Laser
Use the following procedure when you are finished using the laser and need to shut it down.
► Procedure
1. Push the Laser On toggle switch (on the front panel) to turn the laser off. Make sure that the
Laser On LED goes off.
2. Turn the master Power key (on the rear panel) 90 degrees to the vertical “off” position. The green
System Power LED (on the front panel) goes off indicating that system power is off.
3. Disconnect the fiber or SMA cords and power cable as needed.
LASER-785-LAB-02-0409 11