Ocean Optics JAZ-ALP - Manual (Page 11)

1: Setup
013-RD000-001-02-201208 3
General Set-up
The Jaz ALP is adjusted by Ocean Optics for operating in a Jaz stack (see the figure on the previous
page). The Jaz ALP module is placed directly under the spectrometer module.
The laser was adjusted at a distance of 5 meters. While using a 3° aperture on a Gershun Tube and a stack
setup, you can use this adjustment for distances from 2 to 14 meeters between the spectrometer module
and what you are aiming the laser pointer at.
Longer distances may work but to be sure you should readjust your system. Also, you should readjust
your system if you have to use a Jaz stack where the spectrometer is not placed directly over your Jaz
ALP device. For information on how to readjust your JAZ ALP device refer to ‘How To – Adjust the
JAZ-ALP module’ at the end of this document.
Changing Batteries
Before using the device, please insert the 3 AAA batteries (included).
►
Procedure
1. Open the battery case with slight pressure on marked area in direction of the red arrow.
2. Insert batteries in the battery case as shown below.