Specifications – Ocean Optics ISS-2 User Manual

Page 4

ISS-2 Installation and Operation Instructions

134-00000-000-01-201010

3. Remove the four screws that secure the fan to the base of the ISS-2. Take particular care to

save the washers for each screw (typically two per screw), as you will need to replace them
when replacing the screws.

Note

Two of the four screws also hold the front two legs of the ISS-2 in place.

4. Pull the fan gently (along with the legs) away from the lamp to remove the fan.

5. Loosen the setscrew underneath the fan with the included Allen wrench. This setscrew holds

the bulb in place.

Note

You do not need to remove the setscrew – loosening it is sufficient.

6. Remove the setscrews above each of the back legs of the ISS-2 using an Allen wrench (not

included). These screws keep the two halves of the lamp together.

Specifications

Path length:

1 cm

Collimating lens:

BK 7 glass (~360 nm – 2 µm*), 5 mm diameter, f/2

Collimating lens termination:

SMA 905

Filter slot:

Accepts filters up to ¼” (6 mm) thick

Base material:

Aluminum

Spectral range:

360 nm – 2 µm*

Dimensions (LxWxH):

8.9 cm (3.5”) x 5.1 cm (2”) x 3.2 cm (1.25”)

Power input:

12 VDC/800 mA – 2.1 mm center positive

Power output:

6.5 watts

Bulb life:

900 hours

Bulb color temperature:

3100K

Output to bulb:

5 volts/1.3 amps

Output regulation:

0.2% voltage

Time to stabilized output:

~ 30 minutes

Bulb output:

7400 foot-candles (7.4 MSCP)

* Though the product can be used to 2 µm, you can configure it to only “see” to 1100 nm with the
spectrometer.