Ocean Optics ISS-2 - Manual (Page 3)

ISS-2 Installation and Operation Instructions
134-00000-000-01-201010 3
► Procedure
To adjust the fit of the cuvette,
1. Locate the two ball plunger screws.
2. Use the supplied screwdriver to loosen the two ball plunger screws until the end of each screw
is visible in the holder.
3. Insert a cuvette into the cuvette holder.
4. Tighten the ball plunger screws until the cuvette is stationary in the cuvette holder. Do not
over-tighten.
5. Remove the cuvette from the cuvette holder.
Installing Filters
► Procedure
Follow the steps below to install filters in the ISS-2:
1. Loosen the filter clamping screw with an Allen wrench.
2. Insert the filter into the filter slot of the ISS-2. The filter slot accommodates filters up to 6 mm
thick.
3. Gently tighten the filter clamping screw with the Allen wrench to secure the filter in place.
Turning On the Lamp
► Procedure
Follow the steps below to turn on the lamp in the ISS-2:
1. Plug the transformer end of the power cable into a 110 V electrical outlet.
2. Plug the 12V barrel connector on the power cable into the power port on the back of the ISS-2.
3. Screw a fiber into the SMA 905 connector of the ISS-2.
4. Switch the On/Off switch on the rear of the ISS-2 to the On position.
Replacing the Bulb in the ISS-2
► Procedure
Follow the steps below to replace the bulb in the lamp of the ISS-2:
1. Order a replacement bulb (item code LS-1-B) from Ocean Optics.
2. Switch the On/Off switch on the rear of the ISS-2 to the Off position and allow the lamp
sufficient time to cool.