Ocean Optics FHSA-TTL - Manual (Page 7)

000-10000-140-02-1209 1
Chapter 1
Setup
Overview
The following sections provide instructions on unpacking, setting up and adjusting your Filter- and
Cuvette-Holder with Attenuator and TTL-Shutter (FHSA-TTL).
Unpacking the FHSA-TTL Unit
► Procedure
1. Unpack your new equipment carefully. Dropping this instrument can cause permanent
damage.
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present. Contact your dealer for repair or replacement information, if
necessary.
3. Use this instrument in a clean laboratory environment.