Ocean Optics Vivo - Manual (Page 10)

1: Setup and Operation
2 000-vivo-110-02-201208
Unpacking Vivo
The following sections provide instructions on unpacking and setting up your Vivo.
Before using the Vivo for the first time, check for transport damage. Be sure to adhere to all warnings on
the unit and in this manual.
► Procedure
1. Unpack your Vivo device carefully.
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present.
3. Switch on the unit and check if all bulbs are working by pressing both pushbuttons.
WARNING
Do not stare directly into the light beam of the lamps!
Package Contents
Your Vivo package should contain the following:
 Vivo device
 Power supply (12 Vdc @ 2.5 A)
 Three hexagonal socket screw keys (SW 1.3 mm, SW 2.0 mm and SW 2.5 mm)
 SMA barrel
 Magnetic ring
Caution
For optimal use, take care that no objects or liquids enter the device and that there
is no grease residue on the glass window.
Vivo Lamp Controls
The device is running with 12 Vdc @ 2.5 A maximum current. Be sure to use the included power supply
and do not change its voltage settings. Other voltages may cause damage.