Ocean Optics USB-ADP Serial Adapters - Manual (Page 3)

USB-ADP Serial Adapters
USB-ADP Serial Adapters 3
USB-ADP-PX2
The USB-ADP-PX2 features a 15-pin female serial connector that connects the spectrometer to a PX2 Pulsed
Xenon Light Source via a standard 15-pin male-to-male cable.
Items in Shipment
The USB-ADP-PX2 shipment includes the USB-ADP-PX2 adapter block, a
standard 15-pin cable, and a fastening screw.
Installation
Follow the steps below to install the USB-ADP-PX2:
1. Plug the 10-pin interface on the backside of the USB-ADP-PX2 into the
10-pin accessory connector on the USB2000. If using an HR2000
Spectrometer, plug the 10-pin interface on the backside of the USB-
ADP-PX2 into the right half of the 20-pin accessory connector on the
HR2000.
2. Secure the USB-ADP-PX2 in place on the spectrometer with the
fastening screw.
3. Connect the 15-pin cable from the 15-pin port on the USB-ADP-H to the TTL connector on the PX2
Pulsed Xenon Light Source.
USB-ADP-PX2 15-Pin Pinout
Pin 1 Single Pin 10 Ground
Pin 2
Continuous
Strobe
Pin 13 Lamp Enable
Pin 3 +5V
Front view of the USB-ADP-PX2
with 15-pin female serial
connector