Usb-adp-h – Ocean Optics USB-ADP Serial Adapters User Manual

Page 2

USB-ADP Serial Adapters

USB-ADP-PC DB9 Pinout

Pin 2

RS232 Tx

Pin 8

Ext Trig in

Pin 3

RS232 Rx

Pin 9

Analog Out

Pin 5

Gnd

USB-ADP-H

The USB-ADP-H features a 9-pin female serial connector that connects the spectrometer to a handheld PC via a
handheld PC serial cable (not included with the USB-ADP-H).

Items in Shipment

The USB-ADP-H shipment includes the USB-ADP-H adapter block, a USB-
CBL-PS 5V power supply, and a fastening screw.

Note: The USB-ADP-H-E (European version) of the USB-ADP-H does not

include a power supply due to differences in household voltage.

Installation

Follow the steps below to install the USB-ADP-H:

1. Plug the 10-pin interface on the backside of the USB-ADP-H into the

10-pin accessory connector on the USB2000. If using an HR2000
Spectrometer, plug the 10-pin interface on the backside of the USB-
ADP-H into the right half of the 20-pin accessory connector on the HR2000.

Note: If you are using other equipment (such as the USB-BP or the USB-LS-450, connect those items

to the spectrometer in a “daisy chain” style before connecting the USB-ADP-H.

2. Secure the USB-ADP-H in place on the spectrometer with the fastening screw.

3. Connect the handheld PC serial cable from the 9-pin port on the USB-ADP-H to the serial connector of

the handheld PC.

4. Connect the USB-CBL-PS 5V Power Supply to the side of the USB-ADP-H to power the spectrometer.

USB-ADP-H 9-Pin Pinout