Factory Direct Hardware Toto ABA782L - Manual (Page 7)

To the installer
• Be sure to provide the customer with the Installation manual.
• Fill out the necessary warranty information on the back off the Owner manual (for AirBaths).
ABF Installation without access under the floor (continued)
Install Bathtub
• Apply a generous bead of adhesive or silicone (such as GE 5040 Silicone II) to the bottom of the
tub supports.
• Apply a bead of tub and tile caulk (such as GE 7000 Silicone II Paintable Silicone) around the
edge of the base.
• Carefully set the tub into position over the drain body.
• From inside the tub thread on the drain body top. Do not over tighten.
• Be sure the tub is resting on the bottom supports and not the acrylic.
4
Complete Installation
• Fill the tub with water to the overflow and drain the tub while inspecting the waste connections below the floor for leaks.
• With the bathtub now in place wipe off any excess tub and tile caulk around the bottom edge of the bathtub where it meets the
floor.
• Run a bead of tub and tile caulk around the bottom edge of the bathtub where it meets the floor. Wipe off any excess caulk with a
wet cloth.
• Replace the stopper.
5