Factory Direct Hardware Toto ABA782L - Manual (Page 4)

ABA & ABY Installation (continued)
Check Installation
AirBaths: Make sure the blower has ample unobstructed space to draw air and that the space is clear of dust and debris.
All bathtubs: Make sure the bathtub is level and supported by the feet or wood base or mortar sub-floor and not the flange lip.
Clean Up
• When cleaning after installation, do not use abrasive cleaners, as they may scratch and dull the surface. Use warm water and a
liquid non-abrasive detergent to clean the surface.
• Stubborn stains, paint or tar can be removed with isopropyl (rubbing) alcohol. Rinse well and dry with a soft, clean cloth.
• Do not use metal scrapers, wire brushes or other metal tools.
Trial Operation
• Close the drain.
• Fill the bathtub.
• Check for leaks from the air jets (AirBath only).
• Check for leaks from the drain.
• Check plug voltage and verify the Control Panel activates then the “ON” button is
pressed. (AirBath only - see Owner manual)
• Check operation. (AirBath only - see Owner manual)
• After operation, drain the bathtub and run the Automatic Maintenance Cycle.
(AirBath only - see Owner manual)
8
9
10
ABF Installation with access under the floor
Preparation
• Clean, level and prepare the floor for installation.
• Place the unit in the exact installed position on the floor. Be sure the tub is resting on the bottom supports and not the acrylic.
• Determine the location of the drain pipe on the floor by taking measurements of the drain and waste location underneath the unit.
(Drain and waste locations will vary by model.)
• Carefully place the unit on a blanket, cardboard, or other clean protective surface so that the unit is properly supported.
• Clean the drain hole area in preparation of setting the drain. The area should be dry and free of any debris.
1
Drain
Jet Fitting