Crown Audio IQ-P.I.P.-SMT User Manual

Page 11

Page 11

IQ P.I.P.–SMT

circuit board for MA-600 - 3600VZ
and SR I & II. Use the “OUT” position
whenever the unit is installed into a
PIP2-compatible. (CT "10" Series or
MA 5000VZ)

PIP2 SIP Sockets (RN1, RN2)

These eight-pin SIP (single in-line
package) sockets are provided for
full

PIP2 compatibility. IQ-P.I.P.-SMT-

PIP2 modules (required for PIP2-
compatible amplifiers) should come
with the SIP networks already in-
stalled. The SIP networks are not re-
quired and should be absent on
standard

IQ-P.I.P.-SMT modules.

L. IQ Circuit Board (Top)

The top circuit board contains the IQ
communication circuitry, including
the IQ address switch (SW1), ampli-
fier output pad jumpers (JP4, JP5),
PIP2 SIP sockets (RN1, RN2) and the
P.I.P. edge connector.

M. Audio Circuit Board

(Bottom)

The bottom circuit board contains the
audio analog circuitry, including the
input switches (S1, S2).

N. IQ Address Switch (SW1)

An 8-section DIP (dual in-line pack-
age) switch is used to set the IQ ad-
dress of the unit (see Section 4.1).
This switch is located on the top cir-
cuit board. Each IQ component on a
Crown Bus is given a unique IQ ad-
dress so it can be independently
controlled and monitored. Two or
more IQ components of the same
type should NEVER have the same
address on the same Crown Bus
loop.