Crown Audio Com-Tech "10 Series" - Manual (Page 7)

Page 7
Com-Tech Power Amplifiers
Reference Manual
ILLUSTRATIONS
1.1 Com-Tech Amplifiers (120 VAC, 60 Hz Units) ............................. 8
2.1 Front Facilities ......................................................................... 10
2.2 Rear Facilities ......................................................................... 11
3.1 Mounting Dimensions .............................................................. 12
3.2 Top View of a Rack-Mounted Unit ............................................ 13
3.3 Extra Cooling with a Rack-Mounted Blower ............................. 14
3.4 Wiring for Dual 8/4 Ohm Mode ................................................ 15
3.5 Wiring for Dual 70 Volt Mode ................................................... 16
3.6 Wiring for Bridge-Mono 70 Volt Mode (140 Volt Output) ........... 17
3.7 Wiring for Parallel-Mono 70 Volt, Bridge-Mono 8/4 Ohm
and Parallel-Mono 8/4 Ohm Modes ......................................... 18
3.8 Balanced Input Wiring ............................................................. 19
3.9 Unbalanced Input Wiring ......................................................... 19
3.10 Infrasonic Filter Capacitor Values ............................................ 20
3.11 Unbalanced RFI Filters ............................................................ 20
3.12 Balanced RFI Filters ................................................................ 20
3.13 Connecting the RSVP Module ................................................. 21
3.14 Wire Size Nomograph ............................................................. 22
3.15 Inductive Load (Transformer) Network ..................................... 23
3.16 Loudspeaker Fuse Nomograph ............................................... 24
4.1
Indicators ................................................................................ 25
4.2 ODEP, IOC and Signal Presence Indicator States .................... 26
4.3 Input Sensitivity Switch ............................................................ 28
5.1 Circuit Block Diagram ............................................................. 30
6.1 Com-Tech 210 Minimum Power Matrix ..................................... 35
6.2 Com-Tech 410 Minimum Power Matrix ..................................... 36
6.3 Com-Tech 810 Minimum Power Matrix ..................................... 37
6.4 Com-Tech 1610 Minimum Power Matrix ................................... 38
6.5 Com-Tech 210 Maximum Power Matrix .................................... 39
6.6 Com-Tech 410 Maximum Power Matrix .................................... 40
6.7 Com-Tech 810 Maximum Power Matrix .................................... 41
6.8 Com-Tech 1610 Maximum Power Matrix .................................. 42
6.9 Typical Frequency Response .................................................. 43
6.10 Typical Damping Factor .......................................................... 43
6.11 Typical Output Impedance ...................................................... 43
6.12 Typical Phase Response ......................................................... 44
6.13 Typical Crosstalk ..................................................................... 44
7.1
Com-Tech 210 Power Draw, Current Draw and
Thermal Dissipation at Various Duty Cycles ............................. 45
7.2 Com-Tech 410 Power Draw, Current Draw and
Thermal Dissipation at Various Duty Cycles ............................. 46
7.3 Com-Tech 810 Power Draw, Current Draw and
Thermal Dissipation at Various Duty Cycles ............................. 46
7.4 Com-Tech 1610 Power Draw, Current Draw and
Thermal Dissipation at Various Duty Cycles ............................. 46
8.1 PIP2 Adaptor Connection ........................................................ 47
8.2 Installing a PIP Module ............................................................ 47