Crown Audio DBC Network Bridge - Manual (Page 21)

DBC Network Bridge
Operation Manual page 21
4 Operation
Figure 4.2 Back Panel Controls and Connectors
4.2 Back Panel Controls and Connectors
J. IEC AC Power Inlet
Accepts an IEC AC power cord. The DBC Network Bridge has a universal
power supply, and may be operated on AC line voltages from 100 VAC to 240
VAC at 50 Hz or 60 Hz.
K. Multifunction Control Port
One DB37M for analog inputs, digital inputs, +5VDC, +10VDC and ground. 8
input-switch closures, 8 analog 0-10VDC inputs, 16 output contact closures,
+10VDC power source (1A), GND (1A+).
L. Primary Network Connector
RJ45 connector for primary CobraNet network connections (100Mbit CAT 5).
Supports TCP/IQ communications with CobraNet digital audio channels.
On the connector are two LEDs (see detail drawing below). The left LED lights
yellow when the port is in use and will blink if the device is also the conductor
(the CobraNet timing master device). The right LED lights green when link is
established and blinks when network activity is detected. Both LEDs flash yel-
low in unison to report a fatal error.
M. Secondary Network Connector
RJ45 connector for secondary (redundant or backup) CobraNet network con-
nections (100Mbit CAT 5). Supports TCP/IQ communications with CobraNet
digital audio channels.The SECONDARY connection is similar to the Primary,
but is active only in case of a fault in the CobraNet network attached to the
PRIMARY. The secondary LEDs work in the same way as the primary ones.
N. AES/EBU Digital Audio Input
DB25 female connector accepts eight AES3 digital audio signals. Pinout
matches Dolby #778 AES input/output card for CP-650.
O. Analog Audio Input
DB25 female connector accepts eight balanced analog line-level analog
inputs. Pinout matches Dolby CP-650 analog output.
P. Aux Input Level Controls
Screwdriver-set, calibrated gain potentiometer (one per channel) for adjusting
the input gain to the input signal level. These can be used to compensate for
different microphone sensitivities. Control range is from –12 dB to +20 dB.
Q. Aux Inputs
2 female XLR balanced inputs for speech reinforcement or announcements.
Switchable between mic, line, and mic with phantom power.
R. Monitor Out Connector
3-pin Phoenix-type connector supplies a balanced analog line-level output
signal which can feed a powered monitor loudspeaker. This output can be
switched to monitor:
•
Cinema processor output signals (+20 dBu maximum output level)
• Pre-amp input signals
• Post-amp output signals
S. Aux Input Mic/Line/Phantom Switch
Each input has a three-position “M L P” selector switch for mic
level, line level, or mic level with phantom power.
• Select the M position for microphone signal levels up to
+7dBu (0 dbu = 0.775 volt).
• Select the L position for line level signals up to +32 dBu
• Select the P position for mic inputs that require +24 VDC phantom power.