beautypg.com

Factory Direct Hardware Hansgrohe 39410 Axor Citterio User Manual

Page 4

background image

4

Installation Considerations

This unit requires a 3/4” female pipe fitting, recessed 3/8” behind the surface of the

finished wall.

Tools required: 12 mm Hex wrench (not included; available at auto parts stores); 3 mm

hex wrench (included), Teflon

TM

tape, waterproof bathroom sealant.

Installation Instructions

Seal the wall around the female pipe fitting

using a good quality waterproof bathroom

sealant.

Wrap the mounting piece clockwise with 2-3

layers of good quality plumbers’ thread tape.

Screw the mounting piece into the pipe

fitting. Tighten with the 12 mm Hex wrench.

Do not overtighten! The mounting piece

should extend 1 - 1 1/4” outside the surface

of the finished wall.

Slide the escutcheon over the mounting

piece, with the retaining pin on the top.

Slide the tub spout over the mounting piece

until flush with the escutcheon.

Secure the tub spout to the mounting piece

with the set screw, using the 3 mm Hex

wrench.

Starck Tub Spout

10410XX1