Factory Direct Hardware Hansgrohe 32314 Talis S - Manual (Page 7)

7
Install the spout escutcheon.
Firmly press the spout over the tee and diverter. Tighten
the set screw with the included 3 mm Allen wrench.
CAUTION: do not overtighten the set screw or the o-rings
on the diverter will deform, which will cause a leak.
Install the pull rod. The threaded end of the pull rod must
go into the hole in the pin.
Press the diverter assembly firmly into the spout tee until
it is fully seated. Turn the guide bushing so that the slot
faces the rear of the spout.