Dexter Laundry T-900 (30-Cycle) - Manual (Page 15)

15
level for this segment is displayed. If no change is required, then
continue to the next instruction. If a change is required, then use the
SCROLL UP/SCROLL DOWN buttons to change the water level. {"HI" is a high
water level and "LO" is a low water level} When the desired water level
is selected, continue to the next instruction.
When the No Water bath is selected, the water level has no effect. Either
water level can be selected.
9. Push the green ENTER button. (The water level has now been entered.)
The Injection Source LED lights and the Water Level LED is out. The
injection source for this segment is displayed. If no change is required,
then continue to the next instruction. If a change is required, then use
the SCROLL UP/SCROLL DOWN buttons to change the injection source. See the
Injection Source table for proper selection. If zero is selected, then no
injection source is active for this segment. When the desired injection
source is selected, continue to the next instruction.
When the No Water bath is selected, injection signals are prohibited by the
electronic controller. The programmed injection source value is ignored.
10. Push the green ENTER button. (The injection source has now been entered.)
The Spin Time LED lights and the Injection Source LED is out. The spin
time for this segment is displayed. If no change is required, then
continue to the next instruction. If this value requires changing, then
use the SCROLL UP/SCROLL DOWN buttons to change the spin time in 1 min.
increments to the desired value, then continue to the next instruction.
Settings range is from 0 min. to 10 min. except for the Final Rinse/Extract
segment where the setting range is 1 min. to 10 min. REMINDER: If the spin
time is set to zero, there will be no spin at the end of the bath.
11. Push the green ENTER button. (The extract time has now been entered.)
Once depressed, the Spin Time LED is out and the editing of one segment is
complete. The next sequential cycle segment LED lights, unless the segment
edited above was the Final Rinse/Extract segment. If the Final
Rinse/Extract segment is edited, after step eleven, the cycle programming
is complete and the machine will return to the Programming Mode awaiting
a cycle select (Step 3).
To exit the programming mode, depress the red STOP button when one of
the nine cycle segment LED lights are lit. The programming changes made
prior to the program exit are retained and the cycle is updated.
PROGRAMMING INSTRUCTIONS - ENTERING NEW CYCLE
The T900/T950 comes from the factory with 29 preset wash cycles programmed into
the washer. Although these cycles are common industry cycles, there may be a
need to add a cycle to meet an exact application. This can easily be done with
the following instructions. Note: It is recommended when cycle(s) are made the
cycle number and the cycle steps be documented for later reference. Blank cycle
sheets have been provided at the end of the Preset Cycle Information section.
The instructions for entering a new cycle are the same as the editing a cycle